GAI-Tronics XCP0120A Slave Cable Assembly Replacement Kit User Manual
Page 2
Advertising
Pub. 43003-024A
Model XCP0120A Slave Cable Assembly Replacement Kit
Page: 2 of 2
11/01
5. Connect the new SLV-CBL-M ribbon cable to J1 and route it under the cable slot nearest the
mounting position.
6. The exposed SLV-CBL-P cables in the rear run from the CSD PCBA to the CLP PCBA. Remove the
damaged cable from the connector by pulling gently.
7. Connect the new SLV-CBL-P ribbon cable between the CSD board at P25 and the corresponding
CLP board at J25 located in the rear of the unit.
8. Reassemble the front cover using the reverse procedure. Verify the correct ribbon cable positioning
before tightening the slave mid-panel mounting screws to avoid damage to the cable.
9. Reconnect the power to the console.
Figure 1.
Advertising