GAI-Tronics XRM0001A Navigator Control Module Relay Kit - Manual (Page 2)

Pub. 43003-035B
Model XRM0001A Navigator Control Module Relay Kit Page: 2 of 3
d:\radio products-current release\43003\43003-035b\43003-035b.doc
03/06
PC Board Assembly, Part No. RIO-8
The Part No. RIO-8 PCBA can be configured for either Open-Collector (“OC”) or Logic Level (“LL”)
input control. This unit is factory configured to the “LL” mode of operation, and must be converted to the
“OC” mode for use with the Model XCP0600A Output Control Kit.
Convert the Part No. RIO-8 PCBA by changing the jumper arrangement associated with each relay.
Jumper wires JW1 through JW8 are associated with their respectively numbered relays. Refer to Figure 1
for jumper locations.
Move the jumper from the “LL” position to the “OC” position on each relay being used by the Model
XCP0600A Output Control Kit.
N OTE : Failure to change the jumper position to “OC” will prevent the unit from functioning.
Installation
1. Mount the 12-inch Snaptrack ® to the desired surface with the two screws provided in this kit.
2. Snap or slide the relay board into place. Refer to Figure 1 for the interconnection with the Model
XCP0600A (12584-xxx) Output Control Module.