GAI-Tronics XCP0500A Handset Base Kit - Manual (Page 2)

Pub. 43003-041A
Model XCP0500A Handset Base Kit Page: 2 of 2
09/05
ICP9000 Navigator Series MCU
1. Remove the rear panel.
2. Remove the Navigator control ribbon cable from the PPI on the Navigator board and PPI on the main
board. Keep the cable for future use.
3. Position the shorting clips on PP2 to enable operation of the handset. This option must also be
enabled and the sensitivity of the handset/headset microphone set in the User Parameter Menu as
described in the Console Diagnostics section of the Installation and Service Manual, Pub 43004-025.
4. The handset jack plugs into the modular-styled HEADSET / HANDSET jack (P9) at the back of the
MCU.
N
OTE : This jack is not labeled on this product.
N OTE : The Model XAAB002A Audio Accessory Box can also be used for the Navigator application.
This will eliminate the need to access the inside of the MCU.
Figure 1. Handset Base Assembly