Genee World Genee Link - Manual (Page 12)

Accessories
Pointer
LED Lamp
Button
(Mouse left key)
When the pen tip is pressed on a hard surface,
an infra red signal is emitted to the projector
which uses a CMOS detector to detect the
position of the pen. When infrared signals are
emitted, the pen tip will emit red light.
1. Position the pen tip anywhere on the screen
2. Press the tip of the pen on the hard screen.
To draw lines, choose the pen tool.
While pressing the button an infra red signal is
emitted from the tip of the rod and the CMOS
sensor in the projector detects the position of
it. While the IR is emitted, the LED Lamp also
lights red.
1. Position the tip of the pointer on the screen.
2. Push the button to click the target as a
mouse or push and hold the button to draw
a line as a pen.
Pen tip with touch sensor
Light pen
Caution
There’s a sensor on the tip of the pen.
When pressed, energy is consumed
from the batteries. When the pen
is not in use, please switch it off to
avoid power consumption by clicking
the button on the other tip of the
pen. (To check if the pen is switched
off, check if the pen tip is red when
pressed against a hard surface.)
Power switch
8