Harken 7320.10 ESP Jib Reefing & Furling - Manual (Page 13)

ESP Unit 0, 1 13
Assembly Foils/Connectors
1. Identify special length top foil with trim
cap holes.
2. Slide top foil and 2 m foils and
connectors onto wire.
2a. Load connector so bushing cutouts
facing up towards the top of stay.
Note: On top foils under 10" (250 mm),
load top connector so that cutouts for
bushings face down toward
the bottom of stay.
2b. Load onto wire from
top and/or bottom.
3. Make sure that special length top foil
with trim cap holes is at top of stay.
Trim Cap Holes
Trim cap holes
a. Cutout up
b. Top of Stay
Cutout down
Top foil under 10" (250 mm):
Reverse top connector so
bushing cutout is down.
b. Top of Stay