Harken 3852 System B CB & Slider Battcars: built 2007 to present User Manual
Page 10
Advertising
![background image](/files/788636/content/doc010.png)
4. Attach head of sail to headboard
car with clevis pin and cotter pin.
2. Screw threaded stud to terminal.
3. Load toggle using 5mm allen wrench
and 10 mm wrench or nut driver. Tighten
locknut. Do not over tighten.
Make sure
toggle can pivot.
1. Beginning with lower cars, use 5mm
allen wrench and 10mm wrench or nut
driver to attach sail to cars. Tighten
locknut until bottom tip of fastener
is flush with nut.
Slider System
Load Sail on Cars
CB System
Load Sail on Cars
Attach sail to system
beginning with lowest
car. Line up toggle and
insert clevis pin.
If it is a “no wind” day,
start at headboard and
hoist mainsail as you
attach sail to cars.
10
System B (CB/Slider)
3-07
Advertising
This manual is related to the following products: