Harken 3852 System B CB & Slider Battcars: built 2007 to present - Manual (Page 9)

CB System Load Cars on Track
Slider System Load Cars on Track
Part Length Bearing Quantity Ball ø
Number Car Type in mm Color Material per Car Part No. Balls/Set in mm
3852 Headboard Cars (2) 5 3 /
16
132 Brown Torlon ® 60 1526 25 5 /
16
8
3863 Intermediate Car 2 9 /
16
68 Brown Torlon ® 28 1526 25 5 /
16
8
3856 Battcar w/10mm Threaded Stud 4 1 /
4
108 Brown Torlon ® 40 1526 25 5 /
16
8
3857 Battcar w/12mm Threaded Stud 4 1 /
4
108 Brown Torlon ® 40 1526 25 5 /
16
8
3859 Universal Car 4 1 /
4
108 Brown Torlon ® 40 1526 25 5 /
16
8
3860 Reef Car 5 3 /
16
132 Brown Torlon ® 60 1526 25 5 /
16
8
Consult ball chart below to find number of balls for each car. To load balls, place car on edge with retaining clip in place.
Insert balls one-by-one from center of clip and roll into return race. Do not overfill car.
2. Load intermediate car (if
used). Alternate with batten
cars until all cars are loaded.
Mast up: Use halyard to
hold cars.
1. Headboard car: Hold car so
clevis pin head faces up. Align
car on guide section of loader
track and gently roll onto upper
tracks. If cars stick, realign
and roll onto track.
3. Install pinstop. 3850, 3851 Endstop Kit—
Remove bottom 9 1 /
2
" (241mm)
track and install cars.
TIP: Use halyard to hold
cars up
TIP: To load headboard car assembly, angle headboard coupler. Roll car onto tracks. If necessary, remove headboard assembly.
IMPORTANT: To keep balls captive we recommend loading cars onto track without sail installed. Chart below shows correct number of
balls for each car.
Slider cars can be loaded onto tracks with
or without sail attached.
Line up car on guide portion of loader.
Press car towards mast and slide car onto
track. Begin with upper cars and work
down.
TIP: To load headboard car assembly,
angle headboard. Roll car onto tracks. If
necessary, remove headboard assembly.
3-07 System B (CB/Slider) 9
CB System Lost Balls