Harken 3852 System B CB & Slider Battcars: built 2007 to present - Manual (Page 6)

1. Slip top track slugs into mast groove.
Use 1 7 /
16
" (36mm) mounting slug for top
stop.
Short top track lengths Top slug
1 1 /
2
" (38 mm) 3" (76 mm)
2 3 /
8
" (60 mm) 7 /
8
" (22 mm)
Install 3" (76 mm) connector slug at
bottom.
Mast up: Tape 1 7 /
16
" (36 mm) slug even
with top of upper track. Tape other slugs
in place.
2. One drop blue Loctite ® into each
connector slug hole.
3. Thread a 6 x 30 mm screw through
endstop, track, and into endstop slug.
Short top track lengths
1
1 /
2
" (38mm) Use one screw in stop
2 3 /
8
" (60mm) Use both screws
4. Slide slugs into place with putty knife.
Loosely install 6 x 20mm screws.
Mast up: Remove tape.
TIP: Use putty knife to see if screws
are loose enough to slide in groove.
REMEMBER: Tracks may stick when
reaching a spliced area on mast.
5. Loosen top screw. Slide top track up and
position next 6'9 1 /
8
" (2.06m) track.
Mast up: Tighten bottom screw to hold
track.
6. Slide 19 mounting slugs and connector
slug into mast groove.
Mast up: Tape in place.
Put one drop blue Loctite ® into each hole.
CB/Slider Systems Install Track
6 System B (CB/Slider) 6-06