Desa SBVBN(C) - Manual (Page 7)

106828-01C
For more information, visit www.desatech.com For more information, visit www.desatech.com
7
7
CAST IRON STOVE AND B-VENT
BURNER SYSTEM ASSEMBLY
Continued
INSTALLING B-VENT BURNER SYSTEM INTO
STOVE BODY
1. Carefully lift burner system and place into stove body from
the rear of stove.
2. Place the left and right grate tops into the top of stove body. Dis-
card center grate top of stove and replace with center grate top
provided with burner system.
Figure 15 - Installing Burner System Into Cast Iron Stove Body
Cast Iron
Stove Body
Burner
System
Right Top Grate
Center Top Grate
(Included with
Burner System)
Left Top
Grate
NOTICE: If installing blower in an existing stove
burner system with gas connections, shut off gas
supply and disconnect heater from gas supply. Con-
tact a qualified service person to do this.
INSTALLING OPTIONAL BLOWER
ACCESSORY
1. Remove 4 hex screws securing rear cover to back of stove body
(see Figure 16).
2. Separate bottom cover from rear cover by loosening the 8
mounting screws (see Figure 16).
3. Align the holes in the top mounting tabs of blower with the
holes in wall of rear cover. Using the 4 screws provided, mount
blower and tighten screws securely (see Figure 17).
4. Attach thermal switch and bracket to inside rear cover wall with
two hex head screws provided as shown in Figure 17. After se-
curing bracket to rear cover, carefully bend along existing bend
line on bracket to almost a 90° angle (see Figure 17). This will
allow thermal switch to be positioned against stove rear wall
and sense temperature when in operating mode.
Figure 16 - Removing Rear Cover and Bottom Cover from Stove
Body
Stove Body
Rear Cover
Bottom Cover
Mounting
Screws
Mounting
Screws
Hex Screws
Figure 17 - Blower Assembly, Speed Control, and Thermal
Switch Locations
Speed
Control
Blower
Control
Knob
Locknut
Blower
Assembly
Thermal Switch
and Bracket
Control Shaft
TOP VIEW
Mounting Holes
Mounting Holes
Screws
CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY
Installing B-Vent Burner System Into Stove Body
Installing Optional Blower Accessory