HONDA 2010 CR-V - Manual (Page 108)

Make sure the removed head
restraints are securely stored.
Make sure the head restraint locks
in position when you reinstall it.
When reinstalling a head restraint,
put the legs back in place. Then
adjust it to the appropriate height
while pressing the release button.
When a passenger is seated in the
rear center seating position, make
sure the center head restraint is
properly adjusted.
To remove a head restraint, pull it up
as far as it will go. Push the release
button, then pull the restraint out of
the seat-back.
To pivot the outer head restraint
down for better visibility, press the
tilt button on the side of the head
restraint. It folds down forward. To
raise the head restraint, pivot it up
by hand. Make sure the head
restraint locks in position.
Seats
Removing the Head Restraint
102
RELEASE BUTTON
Rear Outer Position Rear Center CUSHION
LEGS
SEAT-BACK
CUSHION
TILT BUTTON
Failure to reinstall the head
restraints can result in severe
injury during a crash.
Always replace the head
restraints before driving.
09/07/30 11:02:25 31SWA630_107