Hypertherm THC X-Y Table Product Configuration - Manual (Page 12)

1-9 X-Y Command THC Product Configuration Manual
SPECIFICATIONS & UNIT MOUNTING
SYSTEM UNIT MOUNTING
Detailed installation instructions are included with the system.
Mount the electrical control units (THC control module and plasma interface assembly) as required
using customer supplied hardware. Do not allow the units to lay unsecured on top of cabinets or on
the floor.
THC Control Module
Mount the THC control module close to the CNC controller for easy access to the THC system
power and to provide easy access for routing and connecting cables. The unit can be mounted in
any position except with the power module (AC receptacle and switch) facing up.
See Figure 1-8 for mounting details.
12 in.
(305 mm)
17.25 in.
(438 mm)
4 Mounting Holes, requiring 1/4
inch (6 mm) fasteners
Figure 1-8 THC Control Module Mounting Details