Disc Makers KDC-W7027 - Manual (Page 16)

16 | English
General features
External Display Switching
Switching the display in the External Display
connected.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [3] button.
Refer to 'Notes on Multi-function Key System'
(page 9).
2 Enter display control mode
Press the [3] ("DISP") button.
3 Select the display
Press the [4] ("OUT") button.
"OEM DISP" is displayed.
Each time the button is pressed the display
switches.
4 Exit display control mode
Press the [6] button.
Auxiliary Input Display Setting
Selecting the display when this device is switched
to Auxiliary input source.
1 Select Auxiliary input source
Press the [SRC] button.
Select the "AUX" display.
2 Enter Auxiliary input display setting mode
Press the [NAME.S] button for at least 2
seconds.
The presently selected AUX Name is blinks.
3 Select the Auxiliary input display
Press the [ 4] or [¢] button.
Each time the button is pressed it switches
through the below displays.
• "AUX""
• "TV"
• "VIDEO"
• "GAME"
• "PORTABLE"
• "DVD"
4 Exit Auxiliary input display setting mode
Press the [NAME.S] button.
• When operation stops for 10 seconds, the name
at that time is selected, and Auxiliary input display
setting mode closes.
• The Auxiliary Input Display can be set only when the
built-in auxiliary input or the auxiliary input of optional
KCA-S210A is used.
Panel Position Setting
Setting the angle or back-forward position of the
control panel.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "PNL" is
displayed above the [4] button.
Refer to 'Notes on Multi-function Key System'
(page 9).
2 Enter Panel Position Setting mode
Press the [4] ("PNL") button.
3 Select the item for adjustment
Press the desired [2] — [5] button.
Each time the button is pressed the items that
can be adjusted switch as shown below.
Adjustment Item Button Display
The panel tilts upwards. [2] "ANG–"
The panel tilts downwards. [3] "ANG+"
The panel slides backward. [4] "SLD–"
The panel slides forward. [5] "SLD+"
4 Exit Panel Position Setting mode
Press the [6] button.
• The control panel may be interfered with the shift
lever or another part depending on the angles of the
control panel.
Set the angle to avoid any interference.
• When a hard rubber frame is mounted
Do not use with the panel slid in the forward
direction.
If so, the hard rubber frame will interfere with the
panel when the angle is adjusted downward.
• No sound is produced while the panel is operating.