Disc Makers KDC-W7027 - Manual (Page 34)

34 | English
Menu system
Contrast Adjustment
Adjusting the display contrast.
Display and Setting
"Contrast 0"
…
"Contrast 5" (Original setting)
…
"Contrast 10"
Dimmer
Dimming this unit’s display automatically when
the vehicle light switch is turned ON.
Display Setting
"Dimmer ON" The display dims.
"Dimmer OFF" The display doesn’t dim.
OFF Wait Time Setting
Setting the time until the faceplate hide
operation starts after the power is turned OFF.
The faceplate can be removed only during the set
time period.
Display and Setting
"Off Wait 0s"
…
"Off Wait 3s" (Original setting)
…
"Off Wait 25s"
In Standby mode
Eject angle setting
This function sets the opening and closing
operation of a panel when a disc is inserted and
when it is ejected.
Display Setting
"EJCT ANG SLP" Opens and closes the panel while maintaining
the angle of the control panel to the set angle.
"EJCT ANG LVL" Opens and closes the panel after setting the
angle of the control panel to the horizontal
position.
In Standby mode
Panel action setting
Sets the panel movement when the panel action
(back/forward movement) is set to its most end
position.
Display Setting
"PanelCNT 1" No angle can be adjusted if the panel position
has been set to its most end position. Also, if you
have set the angle below the horizontal position,
the angle is set to horizontal when you set the
panel to its most end position.
"PanelCNT 2" The angle can be adjusted regardless of the
panel position.
System Q Setting
Setting whether the display indicates the System
Q factors (Bass center frequency, Bass Q factor,
Bass extend, Middle center frequency, Middle
Q factor, and Treble center frequency) in Audio
control.
Display Setting
"SystemQ ON" The System Q factors are displayed.
"SystemQ OFF" The System Q factors aren’t displayed.
In Standby mode
Switching preout
Switching the preout between the rear and
subwoofer. (In subwoofer it outputs without
effect from the fader control.)
Display Setting
"SWPRE Rear" Rear preout.
"SWPRE Sub-W" Subwoofer preout.