Hypertherm RT60 Retrofit Torch - Manual (Page 37)

OPERATION
4-10 RT60 / RT60M Operator Manual
0
Gouging
Hold the torch so that the nozzle is within 1/16 inch (1.5 mm) from the workpiece before firing the torch.
Hold the torch at a 45 degree angle to the work
piece. Pull the trigger to obtain a pilot arc. Transfer
the arc to the work piece.
Maintain a 45° angle, approximately, from the
workpiece.
Feed into the gouge.
Note: A heat shield is available for added hand and
torch protection, Part No. 220049. 45°
WARNING
SPARKS AND HOT METAL CAN INJURE
EYES AND BURN SKIN
When firing the torch at an angle, sparks and hot metal will spray out from the
nozzle. Point the torch away from yourself and others.
Direction of travel