IBEA 4000 Series - Manual (Page 34)

ENGLISH GB
34
distribute the oil inside the engine; observe the piston
location through the spark plug hole; pull the recoil
starter handle slowly until the piston reaches the top of
its travel and leave it there).
9. Install the spark plug (do not connect ignition cable).
10.Cover the chain and the guide bar with the guide bar
cover before putting them in storage.
WARNING
DO NOT STORE IN ENCLOSURE
WHERE FUEL FUMES MAY ACCU-
MULATE OR REACH AN OPEN
FLAME OR SPARK.
12. LIMITED WARRANTY
S.N. n.°
BOUGHT BY :
DEALER :
DATE :
...........................
This chain saw has been designed and produced with the most advanced technology. The manufacturer
guarantees its products for 24 months,according with country legislation, from the date of purchase, with
the exception of products for continuous professional service, used for third parties witch are guaranteed
for 12 months from the date of purchase.
LIMITED WARRANTY
1) Warranty starts on the date of purchase, the manufacturer will supply free of charge any part defective
in materials and workmanship. Warranty does not provide for the replacement of the machine.
2) Product failures will be scheduled and repaired according to the normal work flow; any possible delay
cannot lead to damages nor to an extension of the warranty period.
3) Claims under warranty will be accepted on submission to your Authorized Service Dealer of the
completed and duly stamped. Warranty Certificate together with the original purchase document stating
the date of purchase.
4) Warranty fails in case of:
- evident lack of maintenance;
- incorrect use of the machine or tampering;
- use of incorrect fuel and or lubricants;
- use of non-genuine parts;
- repairs made by unauthorized service people.
5) Parts subject to wear and tear such as cutting items, clutch or cutting safety devices filters, clutch
etc., are not covered by guarantee.
6) Claims for damages incurred during transportation have to be immediately reported to the carrier:
failure to do so will invalidate the warranty.
7) Should any failure occur during or after the warranty period, the customer has not the right to interrupt
payment nor to a price discount.
8) The manufactorer is not responsible for any direct or indirect damage caused to persons or things by
failures of the machine or by a forced suspension in its use.