ikan IKW1-A - Manual (Page 11)

11
IV. OSD MENU
Pairing Procedure Between Transmitter and Receiver
1) On the Receiver, pull up Menu > Configure External Inputs and select
Receive Mac Address.
2) Press the Pairing button on the transmitter. After a few seconds, a
confirmation screen, denoting that pairing was successful, will be displayed
(FIGURE 7):
FIGURE 7
3) Press Enter and Menu to connect.
*NOTE 5:
1) When using two or more transmitters, maintain a connection between the first transmitter
and its receivers before turning on additional units. Do not pair more than four receivers to
one transmitter at a time—signal loss may occur.
2) In such case, re-link units manually (to reauthenticate WiFi connection). Turn on
transmitter and wait until LED is on before turning on additional transmitter.
3) To prevent interference between transmitters, keep transmission units a minimum of three
feet (1 meter) apart.