Important safety instructions, Warnings, Electric shock hazard – Dynex DX-LDVD22-10A User Manual
Page 6: Lightning, Power lines, Handling the lcd panel, Replacement parts, Safety check, Power source, Cautions
 
2
Important safety instructions
Important safety instructions
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near water.
6 Clean only with dry cloth.
7 Do not block any ventilation openings. Install in accordance with 
the manufacturer's instructions.
8 Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that 
produce heat.
9 Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with one 
wider than the other. A grounding type plug has two blades and 
a third grounding prong. The wide blade or the third prong are 
provided for your safety. If the provided plug does not fit into 
your outlet, consult an electrician for replacement of the obsolete 
outlet.
10 Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point 
where they exit from the apparatus.
11 Only use attachments/accessories specified by the manufacturer. 
12 Use only with a cart, stand, tripod, bracket, or 
table specified by the manufacturer, or sold with 
the apparatus. When a cart is used, use caution 
when moving the cart/apparatus combination to 
avoid injury from tip-over. 
13 Unplug this apparatus during lightning storms or when unused
for long periods of time.
14 Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such 
as power-supply cord or plug is damaged, liquid has been spilled 
or objects have fallen into the apparatus, the apparatus has been 
exposed to rain or moisture, does not operate normally, or has 
been dropped.
15 The mains plug is the disconnecting device. The plug must remain
readily operable.
16 The apparatus with grounding-type plug is a class I apparatus.
Class I apparatus need to be connected to earth ground wire to 
prevent possible electric shock. Make sure that you connect the 
class I apparatus to a mains socket outlet with a protective 
earthing connection. 
17 Remote control batteries should not be exposed to excessive heat
such as sunshine, fire, or the like.
18 The apparatus shall not be exposed to dripping or splashing, and
no objects filled with liquids, such as vases, shall be placed on the 
apparatus.
Warnings
Electric shock hazard
To reduce the risk of electric shock, do not remove any cover or expose 
the device to rain or moisture. No user-serviceable parts are inside. 
Refer servicing to qualified service technicians.
Lightning
For added protection for your device receiver during a lightning storm, 
or when it is left unattended and unused for long periods of time, 
unplug it from the power outlet and disconnect any antenna or cable 
system. This helps prevent property damage and personal injury from 
lightning and power line surges.
Power lines
An outside antenna system should not be located in the vicinity of 
overhead power lines or other electric light or power circuits, or where it 
can fall into such power lines or circuits. When installing an outside 
antenna system, extreme care should be taken to keep from touching 
such power lines or circuits as contact with them might be fatal.
Handling the LCD panel
• Your TV’s screen is made of glass. Do not drop your TV or hit, jolt,
or press hard against the LCD panel. If the screen breaks, be 
careful of broken glass. 
• If the LCD panel is broken, make absolutely sure that you do not
touch the liquid in the panel. This may cause skin inflammation.
• If the liquid gets in your mouth, immediately gargle, rinse, and
consult with your doctor. Also, if the liquid gets in your eyes or 
touches your skin, consult with your doctor after rinsing for at 
least 15 minutes or longer in clean water. 
Replacement parts
When replacement parts are required, make sure that the service 
technician uses replacement parts specified by the manufacturer that 
have the same characteristics as the original part. Unauthorized 
substitutions may result in fire, electric shock, personal injury, or other 
hazards.
Safety check
After completing any service or repair to this device, ask the service 
technician to perform routine safety checks to determine that your TV is 
in correct operating condition.
Power source
Operate your TV only from the type of power source indicated on the 
marking label. If you are not sure of the type of power supplied to your 
home, consult an electrician or your local power company.
Cautions
Damage requiring service
Unplug this TV from the power outlet and refer servicing to qualified 
service personnel under the following conditions:
• When the power supply cord or plug is damaged or frayed.
• If liquid has been spilled or objects have fallen into your TV.
• If your TV has been exposed to rain or water.
• If your TV does not operate normally by following the operating 
instructions. Adjust only those controls that are covered by the 
operating instructions because incorrect adjustment of other 
controls may result in damage and will often require extensive 
work by a qualified technician to restore your TV to its normal 
operation.
• If your TV has been dropped or damaged in any way.
• When your TV exhibits a distinct change in performance.
CAUTION
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
This symbol indicates that 
dangerous voltage constituting a 
risk of electric shock is present 
within your TV. This label is located 
on the back of your TV.
This symbol indicates that there are 
important operating and 
maintenance instructions in the 
literature accompanying your TV.
S3125A
DX-LDVD22-10A_09-0042.book Page 2 Monday, March 9, 2009 1:17 PM