Infloor Copper Manifold Guide - Manual (Page 3)

2
AND
3 D
ROP
B
LANKS
(28100 – 2 D
ROP
, 18125 – 3 D
ROP
)
By using the two and three drop manifolds, a manifold of any length can be created using a sweat union between
the manifolds. This is a simple way to get the correct number of drops needed for a particular zone.
2
AND
3 D
ROP WITH
B
ALL
V
ALVE
(28104 – 2 D
ROP
, 18129 – 3 D
ROP
)
Featuring a ball valve and a ½” copper MSWT fitting, these provide a versatile platform for any fitting required.
P
URGE
90°
WITH
A
IR
V
ENT
(28400)
The purge 90° is designed to be connected to one end of the manifold and
allow for air to be purged while filling the system. This fitting simply sweats
on to the end of the manifold.
M
ANIFOLD
M
OUNTING BRACKETS
(28360)
These kits include two mounting brackets for both 1” and 1 ¼” Infloor
copper manifolds. See description below for how to adjust the brackets to
handle the different sized manifolds.