English, Initial start-up – Ivoclar Vivadent IvoBase Injector Short Instructions User Manual
Page 3
1. Initial start-up
Step 1: Unpacking and choosing the appropriate location
Unpack the Injector (please follow the instructions on the outer packaging)
and set it on a suitable flat surface.
Step 2: Removing the transport protection
Remove the transport protection on the safety door and the waste water container.
Step 3: Power connection
Please make sure that the voltage indicated on the rating plate complies with the local power
supply. Please also refer to the technical information contained in the Operating Instructions
(Chapter 9). Now connect the power cord with the power socket and the wall socket.
Step 4: Switching on the Injector
Put the power switch to position I. The Injector then conducts an automatic self-test.
Make sure that the safety door is closed during the test. The standby display appears after the
self-test has been successfully completed. Now the Injector is ready for use.
If the self-test has not been successful, an error message appears.
(For more details, see Chapter 8 in the Operating Instructions.)
P
1
P
2
P
3
P
...
STOP
START
ENTER ESC
– +
i
RMR
IvoBase
Injector
P
1
P
2
P
3
P
...
STOP
START
ENTER ESC
– +
i
RMR
IvoBase
Injector
P
1
P
2
P
3
P
...
STOP
START
ENTER ESC
– +
i
RMR
IvoBase
Injector
P
1
P
2
P
3
P
...
STOP
START
ENTER ESC
– +
i
RMR
IvoBase
Injector
2.
3.
4.
english
A
B
1.