Ivoclar Vivadent Ivomat IP3 - Manual (Page 8)

3.1 Components
The IVOMAT IP3 consists of the following components:
– Apparatus with air filter control
– Non-return valve
– 1.5 m compressed air hose
– 1.2 m water drain hose with canister cap
– Canister hose with sound absorber; polymerization
container in pressure chamber, and 3 object clips
secured to removable lid
– 1 return water container
– 1 replenishing cup
Special accessories
– IVOMAT refill container type IN 1
– Wallfixator
3.2 Functional description
The pressure chamber is equipped with a heater.
In this way, the water can be heated to the temperature
required for the corresponding material.
The pressure chamber is impinged with compressed air
to achieve optimum homogeneity of the material. The
polymerization time can be set by means of the timer.
3.3 Hazardous areas and safety equipment
Description of the hazardous areas:
4.1 Unpacking and checking the contents
Remove the apparatus from its packaging and check for
possible transportation damage. We recommend keeping
the original packaging for future transportation
purposes. Use only the original packaging for
transportation.
Do not carry the IVOMAT IP3 by means of
the power cord. Support the bottom of the
IVOMAT IP3 with both hands to carry it.
4.2 Selecting the location
Place the apparatus on a flat table using the rubber feet.
Make sure that the apparatus is not placed in the
immediate vicinity of heaters or other sources of heat.
Furthermore, protect the apparatus from direct sunlight.
4.3 Connections
Make sure the voltage indicated on the rating plate
complies with the local power supply. If this is not the
case, the apparatus must not be connected.
Connecting the compressed air hose
Make sure that the hose is properly connected.
Power connection
Make sure that the power cord does not touch any parts
of the apparatus that become hot during use.
The electrical installations of the room where
the apparatus is located must comply with
the national regulations and IEC standards.
8
3. Product Description 4. Installation
Hazardous area Type of risk
Safety holder Electrical shock
Air vents Electrical shock
Description of the safety equipment
Safety equipment
Protective effect
Protective conductor Protection from electrical shock
IP44 (system of protection) Protection from electrical shock
Protective thermal switch Protects the IVOMAT IP3
from overheating
IvomatIP3-5sp-sb.qxd 01.07.2005 16:12 Uhr Seite 8