Ivoclar Vivadent Stratos 300 - Manual (Page 18)

This chapter describes the user maintenance and cleaning procedure for the Stratos 300. Only those tasks that can be carried out by
qualified dental lab experts are listed. All other tasks must be performed by qualified service personnel at a certified Ivoclar Vivadent
Service Center.
7. Maintenance and Cleaning
7.1 Monitoring and maintenance
The time for these maintenance procedures depends on the frequency of use and the working habits of the user. For these reasons, the
recommended times are only approximates.
7.2 Cleaning
Protect the Stratos 300 from acids and solvents (e.g.
MMA) to prevent the finish from being damaged.
What
Check centric rubber band for damage and
cracks and replace, if necessary.
Check if knurled screws are dirty.
Check if joint bolt is sufficiently lubricated.
Check if incline support holder and holding
device are dirty.
Part
Centric rubber band
Knurled screw
Joint bolt
Holding device for incline support holder
Frequency
Monthly or as necessary
Weekly
Monthly or as necessary
Weekly or as necessary
What
Knurled screws contaminated with wax or
plaster
Joint bolt contaminated with dust
Frequency
Weekly or as necessary
Weekly or as necessary
Cleaning agent/Measure
Rinse with warm water
Rinse with warm water
18
Stratos 300-BA-WE1.qxd 03.05.2004 11:13 Uhr Seite 18