Ivoclar Vivadent VP3 - Manual (Page 7)

7
Do not use furnaces of other manu-
facturers that are not coordinated with
the pump. Ask the corresponding
manufacturer for further details. The
vacuum pump has been especially
developed for use with the Programat
ceramic furnaces and must be used for
this -purpose only. 2.2 Health and Safety Instructions
• Make sure that the pump is only used for the
indications stipulated in these Operating
Instructions.
• Do not use the pump in areas where there is an
explosion hazard.
• Components connected with the pump must
comply with the pneumatic data of the pump.
• Observe the corresponding safety regulations
wenn connecting the pump to the electronic
network.
• If the operation of the pump is interrupted by
the thermoswitch because of over-heating, the
pump starts automatically once it has cooled
down. Make sure that no danger results from
such an incidence.
• Observe the corresponding safety instructions
for the media used.
• Use only original spare parts.
• The pump complies with the safety regulations
of the following EC guidelines:
73/23 EEC (low voltage guideline)
89/336/EEC (electromagnetic compatibility)
• If the pump has been stored at very low tempe-
ratures or high atmospheric humidity, the pump
as to be dried or left to adjust to the room tem-
perature for approx. 1 hour (do not connect to
the power yet).
Do not work with liquids near the
pump. Should a liquid accidentally
enter the pump, disconnect power and
consult Customer Service. Do not
operate the pump
• The pump is tested for use at altitudes of up to
2000 m above sea level.
• The furnace may only be used indoors.
Any disruption of the protective
conductor either inside or outside the
pump or any loosening of the protec-
tive conductor connection may lead to
danger for the user in case of mal-
function. Deliberate interruptions are
not tolerated.