James Loudspeaker SPL SERIES LCR (1 piece bracket) - Manual (Page 4)

Page 4
Step 11 Now push the speaker up against the
TV, make sure it is aligned to the left and right
edges of the TV, and tighten the 8 mounting tab
screws.
NOTE: At this point, with the 8 screws snug, the
brackets should be captive to the speaker, but
the speaker brackets and speaker should be free
to slide up and down in their slots.
Step 12 You can now remove the screws
holding the speaker brackets to the TV.
Step 13 Place the TV bracket on the TV, over the
speaker brackets.
Step 14 Reinstall the screws into the TV bracket
and tighten. The TV bracket and the speaker
brackets should now be captive to the TV. NOTE
- Make sure to keep the speaker pushed up
against the TV while tightening the bracket
screws.
Step 15 Check the 8 screws on the speaker
mounting tabs to ensure you have tightened
them all.
Step 16 Hang the TV on the wall.
NOTE: We have not discussed when the speaker
wires should be attached this depends on the
type of installation. We leave it up to you to
make the choice of connecting the wires while
installing the brackets or after.
Enjoy your new TV!
James Loudspeaker LLC
535 Airpark Road
Napa, CA 94558
Phone: +1.707.265.6343 Fax: +1.707.265.6334
www.jamesloudspeaker.com
SPL-1pc-Rev B