Q-See QSTD5304 - Manual (Page 18)

QSTD5304 Digital Video Recorder User Manual
18
5. TO REC
If selecting " TO REC", DVR will record when motion is detected. If not, DVR
will not record when motion is detected.
6. ALARM OUT
There are two options: ALARMOUT1 and BUZZER.
• When ALARMOUT1 is selected and an alarm is triggered, the DVR will
give send signal to the alarm out port.
• When BUZZER is selected and the sensor is triggered, DVR will give a
buzzer alarm.
When the alarm output is unselected, DVR will not send an alarm.
7. SCHEDULE
This is the schedule for the motion detection. The default schedule is
everyday. Press "
SETUP” button to set the motion detection schedule.
8. AREA
STEP1 move the cursor to “setup”.
STEP2 Press " SETUP" button to enter the Area Setup submenu.
It displays the selected detection area (refer to Fig. 3.11). There
are four options:
−
ALL: motion anywhere in the area will be detected as shown
in the picture.
−
CUSTOM: You can select part of the area to be detected.
−
NULL: No area will not be open to motion detection
−
BACK: Go back to Motion Alarm Configuration menu.
Fig 3.11 Detection Area Setup
Sub-steps for manually selecting the detection area are described below:
1. In the Area Setup submenu, choose " CUSTOM" option.
2. Press " Enter" key to confirm the operation.
3. Press " Up", "Down", "Left" and "Right" buttons to choose the
area which needs to be detected
4.
Press " Enter" key to select or cancel the area.
5. Press " Esc" button to confirm the option and exit "CUSTOM"
option.
STEP3 Press " BACK" option to go back the Motion Alarm Configuration
menu.