Kleenmaid FE904C - Manual (Page 16)

CONTROL PANEL OPERATION
3.9 Cooktop Controls
3.9.1 Gas Burner Controls
The cooktop burners are ignited by the in-built electronic ignition controls. The controls must be turned anti-
clockwise to operate and can only be turned clockwise to the off position. Alternatively the burner may be ignited
manually using matches, cooktop gas lighters or similar devices, being careful not to risk injury or damage.
To operate the controls ensure the burners are correctly assembled and positioned over the gas burner outlets
and the pan supports are correctly positioned then:–
a) Start the gas flow by pressing down and turning the control knob corresponding to the burner you wish to
use. Pressing down on the control knob causes the igniter to spark.
b) Once the flame is established the knob needs to be pressed and held for approximately 3 seconds until the
thermocouple holds the gas flow open. The control can then be turned to your prequired setting.
3.10 Warming Control (FED and FE90 Models)
The drawer compartment below the oven (left hand oven only for FED) incorporates a heating element and is
perfect for keeping food warm and/or to warm plates and serving dishes. A pilot lamp situated above the Warmer
control indicates when the warming element is on. Allow approximately 10 minutes for the warmer compartment
to pre-heat prior to placing food in to keep warm. When using the drawer to warm plates and serving dishes these
should be placed in the drawer from cold to reduce the risk of breakage. Remember to turn the Warmer control
to the OFF position when the compartment is no longer required for warming.
NOTE: When not in use the drawers may be used to store cookware and utensils. Items which may deteriorate in storage
or with unintentional use of the warming element must never be placed in the compartment.
14