Kleenmaid FE904C User Manual
Page 52
CABINET INSTALLATION INSTRUCTIONS
6.5
Securing the Oven
For FECOMBI and FECOMBIWOK models an anti-tilt bracket is supplied which must be secured to the floor in a
position which allows the rear feet of the appliance to locate into the bracket slots when the unit is pushed back
into the installed position.
For gas appliances, the final gas connection shall be made using a flexible hose or annealed copper tubing of
sufficient length to permit the insertion and removal of the appliance. For gas appliances connected using flexible
hose, a resticking chain must be attached to the anchor point adjacent to the connection to limit movement to
80% of the hose length. Hose to be type A, 65
°C rated with
1
/
2
’’ BSP connections.
For appliances fitted with flexible electrical lead and plug, the general purpose outlet and switch must not be
installed within the appliance recess and must be readily accessible without having to remove the appliance.
Move the appliance into position in front of the opening and ensure rear edge of the appliance is parallel to the
front fascia of the enclosure. Slide the appliance far enough into the cavity to be able to make the final gas and
electrical connections ensuring the gas and electricity are turned off. After all connections have been made, slide
the unit back fully into the recess and secure as necessary.
NOTE: The height of the unit can be altered, if necessary, by adjusting the feet before sliding into the recess.
50