Kleenmaid BX521V - Manual (Page 10)

9
6. Replace crispers and shelves by performing steps
2 through 5 in reverse order.
Note: Be sure to hook shelf frame over notch on top
of support post when replacing shelf frames.
7. Slide crisper glass into place.
To remove or clean crisper drawer assembly for 30"
wide units:
1.
Open refrigerator door as wide as possible and
remove crisper drawers.
CAUTION !
Handle tempered glass shelves carefully to avoid
personal injury or property damage. Shelves may
break suddenly if nicked, scratched, or exposed to
sudden temperature change.
2. Remove glass crisper top by gently pushing up from
underneath. Tilt one end up and pull out.
1
2
3. Raise front of crisper frame free of refrigerator cabinet
rail assembly and pull out of unit.
3
4. Replace crispers and shelf by performing steps 2
through 3 in reverse order.
5. Slide crisper glass into place.
Chiller Fresh TM System (some models)
The Chiller Fresh TM System features a drawer inside a
sleeve. Freezer air circulates between drawer and sleeve.
This systems keeps food fresh longer and up to 5°F (3°C)
colder than refrigerator temperature.
Adjustable Deli Drawer™ (some models)
• Refer to instructions entitled Spillsaver ™ Shelves for
removing and replacing shelf.
• Remove drawer and sleeve by lifting and pulling out.
• Replace drawer by sliding into place.
Garden Fresh™ Crispers
Garden Fresh ™ crispers keep produce fresh longer. Wrap
produce tightly. Do not wash produce before placing in
crispers. Excess moisture could cause produce to spoil
prematurely. Do not line crispers with paper towels. Paper
towels retain moisture.
Garden Fresh ™ crisper control is located below front
shelf trim. Control adjusts humidity in crisper drawers.
Slide control to high for produce with leaves such as
lettuce,spinach or cabbage. Slide control to low for
produce with skins such as cauliflower, corn or tomatoes.
To remove or clean crisper drawer assembly for 33"
wide units:
1.
Remove crisper drawer on handle side of unit.
CAUTION !
Handle tempered glass shelves carefully to avoid
personal injury or property damage. Shelves may
break suddenly if nicked, scratched, or exposed to
sudden temperature change.
2. Remove glass crisper top by gently pushing up from
underneath. Tilt one end up and pull out.
2
1
3. Lift front of crisper shelf frame and remove.
4. Lift front of remaining crisper assembly and remove
support post from center of refrigerator floor.
3
4
5. To avoid interference with door, move remaining
crisper assembly to opposite wall and remove.
5