Kleenmaid BX521V - Manual (Page 6)

5
7. Place refrigerator door on center hinge. Tighten down
top hinge to securely hold door.
8. Use a dime at top to space door 11 /
16
"(18 mm)from
cabinet. Handle side of door should be approximately
1 /
8
" (3 mm) higher than hinge side. Door will become
level when it is loaded with food.
1/8"
(3 mm)
11/16"
(18 mm)
9. Replace hinge cover.
Note: If automatic ice maker water supply is
required, procede to Connect Ice Maker Water
Supply Line . If not, procede to section entitled
Leveling Refrigerator .
Connect Ice Maker Water Supply Line
(some models)
DANGER
!
To avoid electrical shock which can cause severe
personal injury or death. Disconnect power to
refrigerator before connecting water supply.
CAUTION !
Observe the following to avoid property damage:
• Raise stabilizing leg before moving unit.
• Make sure water pressure to water valve is
between 20 and 100 pounds per square inch.
• Tighten adapter fitting and nuts with pliers and
wrenches. Do not overtighten.
• Check for water leaks and correct if necessary
before returning refrigerator to normal location. After
24 hours check again for leaks.
Important
• Before connecting water supply, contact a plumber to
connect coper tubing to household plumbing in
compliance with local codes and ordinances.
• DO NOT use piercing type or 3 /
16
" saddle valves!
Both reduce water flow, become clogged with time and
in addition, may cause leaks if repair is attempted. The
correct type–a shut-off valve–requires a ¼" hole to be
drilled in the water supply pipe before valve attachment.
• Do not install copper tubing in area where temperatures
drop below 32°F (0°C).
Materials Required
¼" O.D. (6 mm) flexible copper tubing
½" open end wrench
Length of copper tubing must reach from water supply
connection to water valve inlet port on back of
refrigerator, plus additional 8 ft. (2 m) of tubing for a
service loop. A service loop will allow refrigerator to be
pulled away from the wall without disconnecting tubing.
Procedure
1.
Remove plastic cap (A) from water valve inlet port (B) .
A
B
2. Place brass nut (A) and brass sleeve (B) on copper
tubing (C) (Brass nut and sleeve are found in your
literature packet.). Insert copper tubing into water
valve inlet port
(D) . Connect brass nut on copper
tubing to water valve inlet port. Make sure copper
tubing is secure by pulling on copper tubing.
3. Turn on water supply to refrigerator and check for
leaks. Correct any leaks at connection. Be careful not
to overtighten connection.
4. Create a service loop using extreme care to avoid
kinks. Secure copper tubing to refrigerator cabinet
with a "P" clamp
(E) . It is important to secure copper
tubing to refrigerator to avoid leaks when pushing
refrigerator back into opening.
A
B
D
C
E
5. Proceed to Leveling Refrigerator for final refrigerator
placement.