Kleenmaid BX521V - Manual (Page 11)

10
D
A
2
C
B
A
1
C
B
D
E
E
F
F G
G
Chiller Fresh TM control (A) is located below front shelf trim.
Control adjusts amount of air circulating around drawer.
Slide control to
COLD for normal refrigerator temperature
and to COLDER for colder temperature. Ice crystals may
form on drawer or food on COLDER setting. Cold air
entering the Chiller Fresh TM drawer can decrease
refrigerator temperature. Fresh food control may need to
be adjusted to a lower number to compensate for colder
air.
Chiller Fresh TM drawer can be moved from the left to the
right side of the refrigerator compartment to accomodate
different storage needs.
To install on left side, see Figure 1. To install on right
side, see Figure 2
1.
Remove drawer (B) by lifting and pulling out. Remove
shelf (C) by lifting from front, releasing hooks from
metal track (D) , then pulling out.
2. Remove plastic cap (E) from back wall of fresh food
section by placing a knife covered with masking tape
underneath cap and pulling forward.
3. Rotate boot (F) 180° to opposite side.
4. Insert plastic cap in hole (G) opposite side of fresh
food section. Confirm cap is snugly in place. Cold air
may cause food to freeze if cap is not replaced.
5. Replace shelf by inserting hooks into metal track and
lowering the front. Use slots 4 though 6 only.
6. Replace drawer by sliding in. Make sure boot fits
snugly over air inlet in back wall.
Storage Rack (some models)
Storage rack (A) provides convenient storage for a large
bottle, eggs, etc.
• Hang rack by hooking over side of shelf.
A
Covered Storage Bucket (some models)
The covered storage bucket has a lid and removable egg
tray. When tray is removed, bucket will accept standard
egg carton, ice, etc.
Dairy Center (some models)
The dairy center provides convenient storage for butter,
cheese, etc.
• Remove dairy center by lifting door (A), pushing
tabs (B) of shelf down on both sides, and pulling out.
• Replace dairy center by sliding in until tabs lock
into place, then lower door.
A
B