Kleenmaid BX521V - Manual (Page 13)

12
CAUTION !
Make sure shelf is secure before placing items on
shelf to avoid property damage.
Freezer Features
Frost-Free System
The fresh food and freezer sections are completely frost-
free. Defrosting is automatic under normal conditions.
Automatic Ice Maker (some models)
• Make sure ice bucket is in place and ice maker arm (B)
is down (C).
B
A
C
• After freezer section reaches normal temperature, the
ice maker fills with water and begins operating. For
optimum ice production, it is recommended that freezer
section be at least half full. Allow 24–48 hours after
installation before first harvest of ice. Ice maker
produces 7 to 9 harvests of ice in a 24-hour period
under ideal conditions.
• After ice is formed, ice maker drops ice cubes into ice
storage bucket. During ice production, ice maker arm (B)
raises and lowers. When ice storage bucket is full, ice
maker arm turns ice maker off
(A) .
Note: Discard first 3 harvests of ice so any impurities left
in the water line after installation are not consumed.
• If you wish to stop automatic ice production lift ice
maker arm (A) . A definite click is heard when proper
position is reached. Ice maker arm will remain in that
position until pushed down.
Ice Service Rack (some models)
Install ice service rack (A) by placing ice service rack on
washers (B) and sliding down.
A
B
Slideout Shelf (some models)
Slide out shelf pulls forward for easy access to items in
back.
• Remove slideout shelf by sliding forward until ball
point (B) beneath center rail (A) catches in molding
groove.
• Grasp shelf by center rail, pull up, and remove.
• Slide in until ball point falls into molding groove.
A
B
Vertical Shelf Divider (some models)
Install vertical shelf divider by completing the following
steps:
1.
Slide prongs of shelf divider beneath desired grill
work, slightly off-center from center rail.
2. Press top of divider down and slide hook assembly
beneath center rail.
1
2
Fixed Wire Shelf (some models)
• Remove wire shelf by pulling out. A sharp tug may
be necessary.
• Replace wire shelf by sliding in until back locks in
place.