K-Patents PR-23 for K-Patents Appendix - Manual (Page 16)

Document/Revision No. IM-GB-PR23-VACCINES: Rev. 1.01 Effective: November 1, 2013
16
Appendix to the Instructions Manual PR-23
Attaching table top stand PR-7605-SS for Sensor and Miniflow cell
Attach the 2.5” Sanitary clamp and the support rod to the base plate. The supplied screw
(M5x16 A4 DIN 912) for attaching the stand is inserted from the bottom of the base plate
through the bottom hole (Figure 3.1). To assemble the Pharma Miniflow cell first locate the
PR-9244-USP O-ring 22.2x3.0 EPDM inside the Miniflow cell (Figure 3.2). Then insert the
2.5” Sanitary clamp for the sensor and mini flow cell.
Finally insert the two PR-9236-USP Sanitary EPDM gaskets and the two PR-9237
0.5” Sanitary ferrules for the inlet and outlet connectios using the two PR-9235 0.5”
Sanitary Clamps.
Sensor can now be connected to flexible hoses and used as a free standing tabletop unit,
see Figure 3.3.
1
Sanitary clamp
and support
Base plate
Retaining screw
Sensor stand assembly
Figure 3.1 Sensor stand assembly: Attaching the clamp and support rod to the base plate.