La Crosse Technology WS-9620 - Manual (Page 7)

7
The Outdoor Thermo-hygro Sensor
• Remote transmission of outdoor temperature and
humidity to Weather Station by 915 MHz
• LCD alternates between temperature and humidity
readings.
• Water-resistant casing
• Wall mounting case
• Mount in a sheltered location. Avoid direct rain and
sunlight
BATTERY INSTALLATION
INSTALL AND REPLACE BATTERIES IN THE WEATHER STATION
The Weather Station uses 2 x AAA, Alkaline batteries. To install and replace the
batteries, please follow the steps below:
1. Remove the cover at the back of the Weather Station.
2. Insert batteries observing the correct polarity (see
marking).
3. Replace compartment cover.
INSTALL AND REPLACE BATTERIES IN THE
THERMO-HYGRO SENSOR
The Thermo-hygro Sensor uses 1 x 3.0V IEC CR2032, Lithium battery.
To install and replace the battery, please follow the steps below:
1.
Pull out the battery holder at the bottom of the sensor.
2. Insert the battery, observing the correct polarity (see marking).
3. Replace the battery holder on the unit.