Denon DN-M991R User Manual
Page 25
25
ENGLISH
(3) Instantaneous play (Hot Start)
Data loading.
Set the cartridge and cue or pause at the track for hot
start playback.
1
• When the data loading is completed, the
STANDBY/CUE button will light and the unit will be set
to instantaneous play (Hot Start) standby.
2
10 TRACK LOAD.
Press the the LOAD button.
• The data for ten tracks starting from the track at which
the cue or pause mode is set is loaded into the hot start
RAM.
1
Starting the play operation.
During instantaneous play (Hot Start) standby, press the
number button (from 1 to 10) that is to be played to start
the instantaneous play (Hot Start) operation.
NOTE:
The hot start data is cleared if the editing or recording operations
are performed during the hot start mode.
Stopping the play operation.
A press the STOP button during the play
operation causes the play to stop and
returns the unit to instantaneous play (Hot
Start) standby.
• When data loading is completed, the CUE LED lights
steadily.
PROGRAM TRACK LOAD.
• Hot start data can also be loaded in the programmed
play mode. The data is loaded in the programmed order.
The programmed play mode is canceled after the data is
loaded.
Preset up to 10 tracks using the parallel remote, the serial
remote or a key board (PS/2 connector, US keyboard with
101 or 104 keys recomended) to enable instantaneous play of
the desired tracks. This function is called instantaneous play
(Hot Start).
• When parallel remote is to be used, a control circuit for
instantaneous play (Hot Start) is required. For information about
the control circuit, contact your store of purchase.
• When serial remote is to be used, contact your store of
purchase.
2-
1
Instantaneous
play
(Hot Start)
Disc
(Example: Track 4 is set to pause)
NOTE: When the stop operation is set during data loading
and the data loading number (from 1 to 10) is
completed, data loading of subsequent tracks is
stopped.
• The PLAY/PAUSE button flashes when an EOM is
detected during playback (when the EOM is turned on
with the presetting).
• When play finishes, the unit returns to instantaneous
play (Hot Start) standby.
1 TRACK LOAD.
While depressing the LOAD button, press the number
button (from 1 to 10) for which data is to be entered.
2-
2
Repeat play.
When the REPEAT button is pressed, the repeat mode is
set.
Press the number button of the track to be played (from 1
to 10) to repeatedly play that track.
• Press the REPEAT button while a track
is being played to repeatedly play that
track.
• Press the REPEAT another time to
cancel the repeat play mode.
3
4
NOTES:
• The instantaneous play (Hot Start) mode will end with one
track.
• A press of a number button during the instantaneous play
(Hot Start) mode will cause the unit to switch to the track of
the pressed number and start playing.
• Cue detection is also performed at the time of instantaneous
play (Hot Start) loading.
Tracks with a setting level less than 10 seconds from the
beginning of the track are loaded from the beginning of the
track.
Even when the level of cue detection is changed after
loading, the pause position will not change until the initial
data is cleared.
Hot Start Load
Hot Start
The number of the button for the track at which
playback started is shown on the display.
2-
3
REPEAT
Set the standby mode and press the MODE button on
the main unit twice to cancel the hot start mode.
• The hot start mode is canceled and the
edit mode is set.
MODE