Dialogic DSI SS7MD - Manual (Page 117)

117
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
Chapter 7: Configuration Command Reference
This chapter describes the commands and parameters used in the config.txt protocol configuration file. These
commands are used by the s7_mgt protocol configuration utility to perform one time configuration of the
protocol stack at startup.
The commands are logically grouped in the following categories:
•
Physical Interface Configuration Commands
•
Monitor Configuration Commands
•
MTP Configuration Commands
•
ATM Configuration Commands
•
ISUP Configuration Commands
•
TUP Configuration Commands
•
SCCP Configuration Commands
•
DTC Configuration Commands
•
TCAP Configuration Commands
•
MAP Configuration Commands
•
INAP Configuration Commands
•
IS41 Configuration Commands