Lumens Technology DC265 - Manual (Page 17)

English - 16
4.4 Start using the DC265
Control Panel Remote Control

When using the remote control, aim at the receptor on the DC265,
and press the power button.
 Once DC265 is turned on, the LED on the control panel will flash a
few times and stay lit. Please contact your distributor if the LED is not
on.
<Note> Once the password page is shown , please key in the
password. If you forget it, please contact your distributor or the
service center.
4.5 Installing remote control holder
Insert the holder over the gooseneck of the camera and push it down.