Marantz SR5005 - Manual (Page 53)

50
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Input Setup
Setting items Setting details
Progressive Mode
Set an appropriate
progressive conversion
mode for the source video
signal.
BD DVD VCR
SAT GAME z AUX1
TV z
Auto : The video signal is automatically detected and the appropriate
mode is set.
Video1 : Select mode suitable for video playback
Video2 : Select mode suitable for video and 30-frame film material
playback.
This item can be set when “i/p Scaler” is set to anything other than
“OFF”.
Aspect
Set the aspect ratio for the
video signals output to the
HDMI.
BD DVD VCR
SAT GAME z AUX1
TV z
Full : Output at 16:9 aspect ratio.
Normal : Output at 4:3 aspect ratio.
“Aspect” can be set when “i/p Scaler” is set to anything other than
“OFF”.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
Input Mode
Default settings are underlined.
The input modes available for selection may vary depending on the input source.
Setting items Setting details
Input Mode
Set the audio input modes
for the different input
sources. Auto : Automatically detect input signal and perform playback.
HDMI : Play only signals from HDMI input.
Digital : Play only signals from digital input.
Analog : Play only signals from analog input.
7.1CH INPUT : Only signals input from the 7.1CH INPUT terminal will be
played back.
• “HDMI” can be set for input sources for which “HDMI” is assigned at
“Input Assign” (vpage 48).
• “Digital” can be set for input sources for which “Digital” is assigned at
“Input Assign” (vpage 48).
• If the input source is set to “TV” or “Game”, it cannot be set to “Analog”.
• When digital signals are properly input, the
indicator lights on
the display. If the indicator does not light, check the digital input
connector assignment and the connections.
• If “HDMI Control” is set to “ON” and a TV compatible with the ARC is
connected via the HDMI MONITOR connectors, the input mode whose
input source is “TV” is fixed to ARC.
This can also be set by pressing A/D on the
remote control unit.
Each time
A/D is pressed, the setting is
changed as shown below.
Auto HDMI Digital Analog
7.1CH INPUT
Decode Mode
Set the decode mode for
input source.
BD DVD VCR
SAT GAME AUX1
TV
CD SIRIUS
Auto : Detect type of digital input signal and decode and play automatically.
PCM : Decode and play only PCM input signals.
DTS : Decode and play only DTS input signals.
• This item can be set for input sources for which
“HDMI” or “Digital” is assigned at “Input Assign”
(vpage 48).
• Normally set this mode to “Auto”. Set “PCM” and
“DTS” when inputting the corresponding input
signal.
• This can also be set by pressing D.MODE on the
remote control unit.