Marantz SR5005 - Manual (Page 65)

62
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Other settings
Remote control settings
• When you connect a remote control receiver unit (purchased
separately) to the REMOTE CONTROL IN terminal of this unit, use
the following procedure to disable the remote sensor function of
this unit.
• The remote sensor function of remote control signals is enabled by
default.
o p ZONE2 ON/OFF RETURN ENTER
n Disabling the sensor function of the remote control
1 To enable the remote signal sensor function, press
and hold ZONE2 ON/OFF and RETURN for 3 seconds.
“IR:< ENABLE >” is displayed.
2
Press o p to select “DISABLE”.
3
Press ENTER .
The sensor function of the remote control signal of this unit is
disabled.
NOTE
If a remote control receiver unit (purchased separately) is not
connected, do not perform this setting. If you do, you will not be
able to operate this unit using the remote control.
n Enabling the remote sensor function
1 To disable the remote signal sensor function, press
and hold ZONE2 ON/OFF and RETURN for 3 seconds.
“IR:< DISABLE >” is displayed.
2
Press o p to select “ENABLE”.
3
Press ENTER .
The sensor function of the remote control signal of this unit is
enabled.
Switching the on-screen display
output mode
Set whether the menu is operated by the monitor connected to the
VIDEO OUT terminal or the monitor connected to the COMPONENT
VIDEO MONITOR OUT terminal.
• The factory setting is “Comp”.
ENTER o p
RETURN PURE DIRECT
1 Press and hold RETURN and PURE DIRECT for 3
seconds.
Corresponding to the video signal format settings,
“OSD Out: 0 Comp 1” or “OSD Out: 0 Video 1” is shown
in the display.
2
Press o p to change the settings according to the
connection method.
Comp Set when the COMPONENT VIDEO MONITOR OUT
connector is connected to a TV.
Video Set when the VIDEO OUT connector is connected
to a TV.
3
Press ENTER to enter the setting.
NOTE
When operating the on-screen display menu using the monitor
connected to the HDMI OUT terminal, either setting may be used
without problem.