Marantz SR6005 - Manual (Page 32)

28
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
n Checking the SIRIUS signal strength and radio
ID
1
Press STATUS until “SIGNAL”
appears on the display.
The display will switch as shown below,
depending on the reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
2 Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
3
Press STATUS until the channel (example: “SR001”)
is displayed.
4 Press TUNING + or TUNING –
and select channel 0 (SR000).
Channel No. and Sirius ID are alternately
shown on the display.
SR000 SiriusID
************ Sirius ID
• Write your own SIRIUS ID for storage use.
Sirius ID :
The strength of both the SIRIUS satellite and terrestrial signals can be
checked “Antenna Aiming” (vpage 52).
n Presetting radio channels (Preset memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1 Tune in the broadcast channel
you want to preset.
2
Press MEMORY .
3
Press SHIFT to select the block
(A to G) in which to preset the
channel (1 to 8 per block), then
press PRESET + , PRESET – or 1 –
8 to select the preset number.
4
Press MEMORY again to complete
the setting.
• To preset other stations, repeat steps 1 to
4.
NOTE
Preset channels are erased by overwriting them.
n Listening to preset channels
Press PRESET + , PRESET – to select
the desired preset channel, then press
ENTER .
• Preset channels can also be selected by
pressing SHIFT/TOP MENU (Block) and 1 –
8 (Channel).
n Searching categories
1
Press o p .
SR001 Hits 1
CAT : Pops Channel category
2
Use o p to select the category, to use ui to select
the desired channel.
n Accessing SIRIUS satellite radio channels
directly
1
Press SEARCH/INFO .
2
Press 0 – 9 to input the channel.
Example: Accessing channel “SR123”:
Press
1 , 2 and 3 .
• If no button is pressed within several
seconds, the channel automatically
switches to the one whose number has
been input.
3
Press ENTER to set that channel.
Reception switches to the selected
channel.
• “UPDATING” is displayed while the encording code is being
updated.
• “SIRIUS UPDATING” is displayed when updating SIRIUS tuner
firmware.
• Refer to “Troubleshooting” – “SIRIUS Satellite Radio” (vpage 91)
regarding other messages.
Tuning in radio stations