Marantz SR6005 - Manual (Page 74)

70
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Registering preset codes
When preset codes are registered in the included remote control unit,
it can then be used to operate any devices you have, such as DVD
players or TVs made by different manufacturers.
NOTE
• No preset codes other than BD , DVD , TV , SAT and CD can be
registered.
• In the factory settings, remote control codes for all Marantz products
are registered.
n Buttons used for operating the devices
q SOURCE ON/OFF
For switching power of each device on or off.
w uio p , ENTER
For menu operation of each device.
e MENU , SETUP , TOP MENU
For displaying the menu of each device.
r 1 , 2 , 3 , 6 , 7 , 8 , 9
t Number button ( 0 – 9 , +10 )
y PRESET + , PRESET –
u TV POWER , TV INPUT
For operating a TV .
This button is enabled in any mode.
For details on operation with the remote control unit, see pages 25,
26, 29, 30, 71.
Registering preset codes
The following two methods can be used for registering the reset
code.
q
Entering a 4-digit code
w Scanning the code table
q Entering a 4-digit code
See the preset code list table for the code to be input.
1 Press and hold down the input
source select buttons for the
appliance to control, and press
SET until indicator blinks
twice.
The back light flashes.
2 Press the 4-digit code for the
appliance using the numeric
buttons (code table at the end of
this book).
• The 4-digit code is shown in the remote
control display.
• When the settings are complete, “OK”
is shown in the remote control display.
• If “NG” is displayed in the remote control
display, repeat steps 1 and 2, and enter the
same code again.
w Scanning the code table
1 Switch the power on of the device
for which you want to set the
preset code.
2 Press and hold down the input
source select buttons for the
appliance to control, and press
SET until indicator blinks
twice.
The back light flashes.
3 Aim the remote control at the
appliance and slowly alternate
between pressing INPUT d
and SOURCE ON/OFF for the
appliance.
The preset code is shown in the remote
control display.
4 Stop when the appliance turns off.
5
Press ENTER once to lock in the code.
Check the registered preset code
1 Press and hold down the
input source select buttons for
appliance to control, and press
SET until indicator blinks twice
and back light flashes.
The back light flashes.
2
Press SEARCH/INFO .
The display flashes twice, after which
the set code is shown for 3 seconds in
the remote control display.