Datalogic Scanning Industrial PDA - Manual (Page 54)

Quick Reference Guide 52
Safety Information
Laser Safety Label
Laser Safety Label
Advisory Statement
Regulatory Statements
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. How-
ever, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following mea-
sures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
CAUTION
Use of controls, adjustments, or performance of procedures
other than those specified herein may result in hazardous
visible or invisible laser light exposure.
CLASS 2 LASER PRODUCT 1.0mW
Max Output: 645 to 660nM
Complies with 21 CFR
1040.10 and1040.11
EN60825 1+A2:2001
This figure illustrates an example of a laser safety
label, which is located on the scanning pod of
laser-based Pegaso units. The label on your unit
may appear different or have different informa-
tion. Please refer to your unit for specific laser
safety requirements.
The Advanced Long Range Laser is rated Class
3R per EN60825-1 and Class II per CFR 1040.
Models with the Linear Imager are rated LED
Class 1 per IEC 60 825-1:2001, only.