Marantz PM-11S3 - Manual (Page 24)

20
ENGLISH
Advanced operations
Setting Auto standby mode
With the Auto standby mode ON, this unit will automatically enter the standby mode after
about 30 continuous minutes of no output from the selected input source.
Press and hold TONE on this unit for 5 seconds or longer.
• Auto standby mode is switched between On and Off with each press of the button.
On
(Factory default) Off
• If the mode is set to off, the display shows “AUTO STBY OFF”.
• This unit will automatically enter standby mode after about continuous 30 minutes in the
following conditions.
• No operation performed on the remote control.
• No operation of this unit.
• The display will show the remaining time for three minutes before the units enters standby
mode.
• In F.C.B.S. connection, only the ID 1 master unit activates Auto standby mode. If the ID 1
master unit is operated with no audio input, set the Auto standby mode to OFF.
Connecting the remote control connectors
When you use this unit connected to marantz audio components, it sends control signals to
operate each component.
n Connection
Use the remote connection cable (supplied with a marantz audio component you want to
connect) to connect the REMOTE CONTROL OUT terminal of this unit to the REMOTE
CONTROL IN terminal of the component to be connected.
n Setting
Set the remote control switch located on the rear panel of the connected audio component to
“EXTERNAL” or “EXT.” to use this feature.
• This setting will disable remote sensor reception of the connected audio component.
• To operate the connected audio component, point the remote control at the remote sensor
of this unit.
• To use the system control to this unit via the connected device, make the connection following
the instructions supplied with the connected device.
REMOTE CONTROL
IN OUT
RC OUT
Input Output
CD player
Option unit
(such as remote control receiver unit)
1.PM-11S3U_ENG_0521.indd 20 2012/05/21 19:03:36