Marantz MT7001 - Manual (Page 4)

4
ENGLISH
WHEN INSTALLING
WARNING
¶
Do not alter any of the parts, or use them for any means other than the intended use.
Doing so may cause the ES7001 to fall and cause injury.
¶
If the installation location is directly above where people walk, use wires or other such
means to prevent the unit from falling, even if the installation location can support the
weight.
¶
Do not clip the ES7001 power cord and cables to the wall, over-bend, or twist them. Doing
so may cause the cable core to short or break, which may cause fire.
¶
Do not hang any extra weight other than the ES7001 on the bracket. Doing so may cause
the ES7001 to fall and cause injury.
¶
The installation work must be performed by 2 or more people. Failing to do so may cause
the ES7001 to fall and cause injury.
¶
Thoroughly check to make sure there are no power cables or pipes inside the walls before
starting the installation work.
¶
Loose screws in any of the parts may cause accidents such as the unit falling. Always
ensure that all screws are fully tightened before installing the unit.
¶
If the wall hanging plate is installed upside down, the ES7001 will fall, which may cause
injury.
¶
Check that the 4 installation screws for the ES7001 are correctly inserted into the
installation holes of the MT7001.
Failing to do so may cause the ES7001 to fall and cause injury.
CAUTION
¶
Do not install so that the ES7001 juts out from the edge of the wall. Doing so may cause
people or objects to knock against it causing injury.
¶
Use commercially available fall prevention bands to prevent the unit from falling.
¶
Marantz cannot accept any responsibility for accidents or damage that result from
defective installation or incorrect use of this unit.
¶
Make sure you do not trap your fingers when installing this unit.
MT7001_E_02_ENG.indd 4 MT7001_E_02_ENG.indd 4 07.9.21 1:03:56 PM 07.9.21 1:03:56 PM