Marantz MT7001 - Manual (Page 5)

5
ENGLISH
INSTALLATION PROCEDURE
q Installing the wall hanging plate onto the wall
Before installing the wall hanging plate, make sure you have read and fully understand all of the
warnings and precautions in this manual.
1. After reading all of the safety precautions in the About the Installation Location section of this
manual, find a suitable installation position for the ES7001 on the wall surface.
2. Prepare 4 anchors and the necessary screws etc that are suitable for the strength and
construction materials of the wall. Prepare screws that are 4~5mm diameter.
3. Use holes q~r on the diagram for the wall hanging plate installation holes.
Following the dimensions shown in the diagram, firstly ensure that q~r are secured, and use
the other holes for reinforcing the installation.
When drilling the anchors and prepared holes in the wall, follow the dimensions shown in the
diagram, and make sure that the installation will be level.
(Unit: mm (inch))
812.8 (32)
154.5 (6-1/8)
69.9
(2-13/16)
36.2 (1-7/16)
160.3
(6-5/16)
143.0
(5-11/16)
1,080 (42-9/16)
31.8 (1-5/16)
6.4 (5/16)
50.8 (2)
q
w
e
r
Enlarged installation hole diagram
4. Securely install the wall hanging plate onto the wall.
• Securely tighten the screws so that there is no looseness, and check that the wall hanging
plate is securely installed onto the wall.
Direction of holes when
installing
Correct Incorrect
Upward
direction
• When installing the plate, make sure it is not upside down. Refer to the diagram below
when installing to make sure the direction of the holes is the same as in the diagram.
Caution:
If the wall hanging plate is installed upside down, the ES7001 will fall, which may cause injury.
MT7001_E_02_ENG.indd 5 MT7001_E_02_ENG.indd 5 07.9.21 1:03:56 PM 07.9.21 1:03:56 PM