Maytag MEDX6STBW Installation - Manual (Page 18)

18
Tighten and adjust leveling legs
2.
If dryer is not level or the same height as the washer, prop up
using a wood block. Use wrench to adjust legs up or down,
and check again for levelness. Once legs are level, make sure
all four legs are snug against the floor before tightening them.
Complete Installation Checklist
q Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q Check that you have all of your tools.
q Dispose of/recycle all packaging materials.
q Check dryer’s final location. Be sure vent is not crushed
or kinked.
q For power supply cord installation, plug into an outlet.
For direct wire installation, turn on power.
q Check that dryer is level. See “Level Dryer”.
q Remove film on console and any tape remaining on dryer.
q Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
q Read “Dryer Use” in your “Use and Care Guide”.
q Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
Reverse Door Swing (Optional)
29" Super Wide Side-Swing Door
Place towel on top of dryer to avoid damaging the surface.
NOTE: Magnetized screw driver is helpful.
Place towel on dryer
1.
Remove bottom screws
2.
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.
Level Dryer
Not Level LEVEL Not Level
NOTE: The dryer must be level for the moisture sensing system
to operate correctly.
Level Dryer
1.
Check levelness of dryer from side to side. Repeat from
front to back.
q Be sure the water faucets are on.
q Check for leaks around “Y” connector, faucet, and hoses.
q If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
If the dryer will not start, check the following:
■ Controls are set in a running or “On” position.
■ Start button has been pushed firmly.
■ Dryer is plugged into an outlet and/or electrical supply
is on.
■ Household fuse is intact and tight, or circuit breaker has
not tripped.
■ Dryer door is closed.
q When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle
and close the door.
If you do not feel heat, turn off dryer, and check the
following:
■
There may be 2 household fuses or circuit breakers for
the dryer. Check that both fuses are intact and tight, or
that both circuit breakers have not tripped. If there is still
no heat, contact a qualified technician.
NOTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.