Maytag MAV7580EWW Installation - Manual (Page 2)

Read this before you start…
TOOLS needed for installation:
• Cutting knife
• Channel lock
• Nut driver
• Level
• Crescent wrench
Proper installation is the responsibility of the purchaser.
SERVICE CALLS PERFORMED AS A RESULT OF POOR INSTALLATION ARE THE
RESPONSIBILITY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
GROUNDED ELECTRICAL OUTLETS are required. See Electrical Requirements.
STANDPIPE DRAIN SYSTEM must be able to accept 1-1/2 inch O.D. drain hose.
Standpipe height of 36 inches is recommended. The drain must permit 23 gallon per
minute flow to evacuate the washer.
NOTE: If the standpipe height is less than 3 feet or greater than 5 feet, refer to the
“DRAIN FACILITY” section to determine if special provisions are needed.
HOT AND COLD WATER FAUCETS must be within 4 feet of the back of the washer.
NOTE: For installations requiring longer hose length, it is recommended to purchase a
double male 3/4” NH coupling and Maytag hose #33-7046 or equivalent.
WATER HEATER set to deliver 140°F (60°C) hot water to the washer.
PROTECTION FROM WEATHER: Do not store or operate washer below 60°F (15°C).
1
2
3
4
1
2
3
4
5
PARTS supplied for installation:
Cable tie to secure drain hose to standpipe, inlet hose or laundry tub
2 washers and 2 screens for water hoses