Maytag MAV7580EWW Installation - Manual (Page 6)

tub. With the tub block in place, retape the lid. After ins
Step 7
To prevent accidental dislodging, secure the
drain hose to the standpipe, inlet hose, or
laundry tub with the tie strap provided in the
parts package.
Step 8
If separate ground is required by local
codes:
An accessory grounding kit (Pa rt No. 1 2 0 0 1 8 7 5 )
containing accessory ground wire, clamp,
ground screw and washer can be purchased
separately, Connect ground wire to back of
unit with the cabinet ground screw and washer.
Secure the other end of ground wire with
clamp to grounded COLD metal water pipe.
NEVER CONNECT GROUND WIRE TO
PLASTIC PLUMBING LINES, GAS LINES, OR
HOT WATER PIPES.
Step 9
Plug the power cord into a properly grounded
electrical outlet.
Consult local building officials and a qualified
electrician if in doubt.
Step 10
The washer is equipped with self-stabilizing
rear legs. The front legs are threaded and can
be adjusted to level the washer.
Place the washer in its final operating location.
Tilt the machine forward until the rear of the
machine is approximately 4 inches off the floor.
Allow the unit to gently drop onto the rear feet.
This causes the rear feet to conform to the
floor and seat solidly.
Step 11
With hands on opposite corners, rock the
washer to check for stability.
With a level, check the washer and make the
n e c e s s a ry adjustments to the front leveling legs.
N OT E :Self-stabilizing rear legs level the rear of
the machine side-to-side. T h ey do not prov i d e
f r o n t - t o - b a ck leve l i n g .
● Improper connection of
the equipment-gr o u n d i n g
conductor can result in a
risk of electrical shock .
C h e ck with a qualified
e l e c t rician or serv i c e m a n
if you are in doubt as to
whether the appliance is
p r o p e rly gr o u n d e d .
● Do not modify the plug provided with the
appliance – if it will not fit the outlet, have a
proper outlet installed by a qualified electri c i a n .
I M P O RTANT SAFETY PRECAU T I O N S
● To prevent unnecessary risk of fire, electrical
shock or personal injur y, all wiring and
grounding must be done in accordance with
the National Electrical Code ANSI/NFPA, No.
70-Latest Revision (for U.S.) or the Canadian
Electrical code CSA C22.1-Latest Revision
(for Canada) and local codes and ordinances.
It is the personal responsibility and obligation
of the appliance owner to provide adequate
electrical services for this appliance.