Installation procedure – Maytag MMV5100AAB Installation User Manual
Page 10
10
INSTALLATION PROCEDURE
PREPARE CABINET OPENING
•
Remove burner grates (if there are any) from top of the range and place a
piece of cardboard or other heavy material over the countertop or cooktop
to protect it. Failure to protect these surfaces could result in product
damage.
•
Remove microwave, all shipping materials and parts. Check the microwave
for any damage such as a misaligned or bent door, damaged door seals and
sealing surfaces, broken or loose door hinges and latches and dents inside
the cavity or on the door. If there is any damage, do not install the oven and
contact an Authorized Service Center.
MOUNTING TEMPLATES
This product comes with an upper cabinet template and a wall template to help
ensure proper installation.
•
Locate the center of the opening where the oven is to be installed. Using a
measuring tape, find and clearly mark the vertical center line of the cabinet
opening on the wall directly under the upper cabinet.
•
Line up paper wall template center line with center line on wall. Tape wall
template to wall. Top of template must be located a minimum of 30" above
cooking surface or countertop.
NOTE: Top of wall template must be on the same level as the front edge of
cabinet
.
THE MICROWAVE OVEN MUST BE LEVEL.
•
Find and mark the location of all wall studs on wall template. If there are no
wall studs in the opening area, do not install microwave oven and consult
with your building inspector.
•
Measure bottom of upper cabinet to line up the paper upper cabinet
template. Trim the edges of A, B and C on upper cabinet template so
template will fit on bottom of upper cabinet. If upper cabinet has a frame
and the bottom of cabinet is recessed, trim template to fit inside the
recessed area. Align center line of upper cabinet template with center line
of wall template. Tape to cabinet bottom.
CAUTION: Do not attempt to install the microwave oven if you cannot find
a wall stud.
Back wall
OTR-Installation-M1.fm Page 10 Wednesday, September 27, 2000 4:03 PM