Measurement Computing Micro 488/EX rev.2.1 - Manual (Page 137)

Section 5 Command Descriptions
5.67
RESET
The system command RESET provides a warm start of the interface. Issuing the
RESET re-initializes the internal IEEE controller hardware, installs the power-on
terminators and the default DAY, DATE, TIME and CASE formats.
If a STARTUP macro has been defined, it will execute. It is also equivalent to
issuing the following commands…
ABORT (If System Controller)
DISARM
ERROR
OFF
LOCAL (If System Controller)
REQUEST 0 (With rsv cleared if peripheral)
TIME OUT 0
TRACE OFF
The RESET command provides a warm start of the interface as well as clearing
all error conditions. Upon detection of the RESET command, the Micro488/EX un-
asserts its serial output handshake line (RTS). It re-asserts it when it is capable of
accepting serial input data. If XON/XOFF handshake is selected, the handshake state is
not effected by the RESET command.
SYNTAX RESET
or
RESE
RESPONSE None
MODE Any
BUS STATES IFC,*IFC,*REN (if SC)
EXAMPLE PRINT#1,"RESET"