Denon AVR-1611 - Manual (Page 36)

33
ENGLISH
Basic version
Simple version
Information
Advanced version
Convenient functions
Sleep timer function
The power automatically goes into standby once the set time has
elapsed.
This is convenient for playing sources while going to sleep.
Press SLEEP and display the time you
want to set.
The “SLEEP” indicator on the display lights.
• The time switches as shown below each
time SLEEP is pressed.
OFF 10 min 20 30 40 50
60 80 70 90 100 110 120
To cancel the sleep timer
Press SLEEP to set “OFF”.
The “SLEEP” indicator on the display turns off.
• The sleep timer setting is canceled if this unit’s power is set to
standby or turned off.
• When power to the main zone is
turned off with the sleep timer,
power in ZONE2 is also turned off.
• If SLEEP on the main unit is pressed,
the same function as with the
remote control unit can be obtained.
Adjusting the volume of the speakers
You can adjust the channel level either according to the playback
sources or to your taste, as described below.
n Adjusting the volume of the different speakers
1
Press ZONE SELECT to switch the
zone mode to “MAIN”.
The “MAIN” indicator lights.
2
Press AMP to set the remote
control unit to amplifier
operation mode.
3
Press CH LEVEL .
Channel Level
C 0.0dB SBR 0.0dB
FL 0.0dB SR 0.0dB
[ ]:CH Sel.
FR 0.0dB SBL 0.0dB
SW 0.0dB SL 0.0dB
Fader
FRONT : REAR
4 Use ui to select the speaker.
The speaker that can be set switches
each time one of the buttons is pressed.
5
Use o p to adjust the volume.
• In the case of a subwoofer, pressing o when it is at “–12 dB” will
change the setting to “OFF”.
When a headphone jack is inserted, the headphone channel level can
be adjusted.
n Adjusting the volume of groups of speakers
(Fader function)
This function lets you adjust (fade) the sound all at once from the
front (front speaker / front height speaker / center speaker) or rear
(surround speaker / surround back speaker).
1
Press ZONE SELECT to switch the
zone mode to “MAIN”.
The “MAIN” indicator lights.
2
Press AMP to set the remote
control unit to amplifier
operation mode.
3
Press CH LEVEL .
Channel Level
C 0.0dB SBR 0.0dB
[ ]:CH Sel.
FR 0.0dB SBL 0.0dB
SW 0.0dB SL 0.0dB
FRONT : REAR
FL 0.0dB SR 0.0dB
Fader
4
Use i to select “Fader”, then
select the item to be adjusting
using o p.
5 Use o p to adjust the volume of the speakers.
(o : front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker is adjusted
to the lowest value of -12 dB.