Denon AVR-1611 - Manual (Page 38)

35
ENGLISH
Basic version
Simple version
Information
Advanced version
Playback
1
Switch ZONE SELECT to “ZONE2”.
The remote control unit switches to the
operating mode for ZONE2.
Input source
select buttons
2
Press AMP .
3
Press ZONE/DEVICE ON to turn
on the ZONE2 power.
The indicator on the display lights.
• Also, pressing any of input source select
button in standby mode turns on the power.
• When ZONE/DEVICE OFF is pressed, ZONE2
turns off.
• Power in ZONE2 can be turned on or off by
pressing ZONE2 ON/OFF on the main unit.
4 Press the input source select button.
The audio signal of the selected source is output to ZONE2.
• Turn SOURCE SELECT after
pressing ZONE2 SELECT on
the main unit to select an input
source.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select “MAIN” in step 1 then
press
ZONE/DEVICE OFF .
Adjusting the volume
Use VOL df to adjust the volume.
G Adjustable rangeH – – – –80dB – –40dB – 18dB
(When the “Volume Display” (vpage 53) setting is “Relative”)
G
Adjustable rangeH 0 – 41 – 99
(When the “Volume Display” (vpage 53) setting is “Absolute”)
• At the time of purchase, “Volume Limit” (vpage 53) is set to
“–10dB (71)”.
Turn MASTER VOLUME after pressing ZONE2 SELECT on the main
unit to adjust the sound volume.
Turning off the sound temporarily
Press MUTE .
The sound is reduced to the level set at “Mute Level” (vpage 53) in
the menu.
• To cancel, either adjust the volume or press
MUTE again.
• The setting is canceled when the zone’s power is turned off.
Quick select function
It is also possible to save three settings for ZONE2.
n Saving the settings
1 Set the items below to the settings
you want to save.
q Input source (vpage 35)
w Volume (vpage 35)
2
Switch ZONE SELECT to
“ZONE2”.
The remote control unit switches to the
operating mode for ZONE2.
3
Press and hold the desired QUICK SELECT button until
“Memory” appears on the display.
The current settings will be memorized.
G Quick select defaultsH
Input Source Volume
QUICK SELECT 1 BD –40dB
QUICK SELECT 2 SAT/CBL –40dB
QUICK SELECT 3 DOCK –40dB
n Recalling the settings
1
Switch ZONE SELECT to
“ZONE2”.
The remote control unit switches to the
operating mode for ZONE2.
2
Press QUICK SELECT at which the
settings you want to call out are
saved.
Naming quick select settings
See “Quick Select Name” (vpage 54).